BICHENGPCBBicheng Technologies Limited
全部文章

电路板基本术语释义

发布于 2025-08-11

1.Basic Terms

PCB(Printed Circuit Board) – The board used for electrical connections between electronic components.

Bare Board – A PCB without any components mounted.

Substrate – The base insulating material of a PCB (e.g., FR-4).

Copper Clad Laminate (CCL) – A substrate coated with copper foil.

Trace – The conductive copper lines on a PCB.

Pad – The metal area where components are soldered.

Via – A hole that connects traces on different layers (through-hole, blind via, buried via).

Plated Through Hole (PTH) – A via with conductive plating (copper) for electrical connection.

2. Material-Related Terms

FR-4– The most common glass-reinforced epoxy laminate (UL94-V0 flame retardant).

High-Tg Material – High glass transition temperature material (e.g., Tg ≥170°C) for better heat resistance.

Flex PCB – Flexible circuit board, typically using polyimide (PI) substrates.

Rigid-Flex PCB – A hybrid design combining rigid and flexible sections.

Prepreg – Pre-impregnated bonding material used in lamination.

Solder Mask – A protective coating to prevent solder bridging (commonly green or black).

Silkscreen – Printed markings for component labels, polarity, etc.

/

3. Process Terms

Etching – Chemical removal of excess copper to form circuit traces.

Lamination – Bonding multiple layers under heat and pressure.

Drilling – Creating holes (mechanical or laser drilling).

Electroless Copper Deposition – Chemical copper plating for via conductivity.

Electroplating – Electrolytic deposition of copper, gold, or tin.

Hot Air Solder Leveling (HASL) – Traditional solder surface finish.

ENIG (Electroless Nickel Immersion Gold) – A high-reliability surface finish.

OSP (Organic Solderability Preservative) – Temporary anti-oxidation coating.

Impedance Control – Designing traces to match signal transmission requirements.

4.Design Terms

Gerber File – Standard PCB fabrication file describing layers (copper, solder mask, etc.).

Drill File – Specifies hole locations and sizes.

Footprint – The physical layout of a component’s pads and outline.

Bill of Materials (BOM) – List of all components used.

Design Rule Check (DRC) – Validates PCB design against manufacturing constraints.

High-Speed PCB – Focuses on signal integrity (e.g., differential pairs, length matching).

EMC/EMI (Electromagnetic Compatibility/Interference) – Critical for reducing noise.

5.Advanced Technologies

HDI (High-Density Interconnect) – Uses microvias (<150μm) and fine traces.

Buried/Blind Via – Buried (internal layers only) / Blind (surface to inner layer).

Via-in-Pad – Via placed within a component pad (requires filling).

Microvia – Small laser-drilled via (≤100μm diameter).

Stackup – Layer arrangement in a multilayer PCB (e.g., 4-layer: signal-GND-power-signal).

6.Testing & Reliability

AOI (Automated Optical Inspection) – Detects visual defects.

ICT (In-Circuit Test) – Electrical performance verification.

Flying Probe Test – Contactless electrical testing.

Thermal Cycling Test – Evaluates thermal endurance.

IPC Standards – Industry standards (e.g., IPC-6012, IPC-A-600).